DRMFG光纤切割刀刀片：
1、DR精细钨钢，HRA≥92.5
2、刀片可旋转16个转位
3、每刀位平均切割寿命约3000 次
4、切割角度＜0.5 度
5、400倍显微镜下全检尺寸
6、质量稳定，完全替代进口
7. 十年制造，服务全球
适用于机型：腾仓 日新 吉隆 DVP等 CT-30,CT -30A，CT-30B，CT-32，CT-38，CT-20,CT-20-11,CT-20-12,和HTC-20 KL-260 280 300 KL-21B DVP-730
DVP-105等
光纤切割熔接不良原因有很多，常见因素有：
1.刀刃或光纤上粘有异物杂质；
2.切割角度不垂直，重新安装调试；
3.刀刃位置太远，切割深度不够，需重新安装。
4.裸纤涂覆层未剥离干净
DRMFG fiber cutting knife blade:
1. DR fine tungsten steel, HRA ≥ 92.5
2. The blade can rotate 12 to the transfer
3. The
average cutting life of each knife is about 3,000 times
4. Cut angle <0.5 degrees
5, 400 times the size of the full
inspection of the microscope of the microscope
6. Stable quality, completely replacing imports
7. Made in ten years to
serve the world
Product Features:
Cutting angle stable
Extension of cutting life
Easy to replace blade
Low temperature cutting is normal
There are many failure reasons for optical fiber cutting and melting.
The common factors are:
1. An impurities sticky on the blade or fiber;
2. The cutting angle is not vertical, reinstall and debug;
3. The blade is too far away, and the depth of cutting is insufficient. You need to reinstall it.
4. Naked fiber coating layer is not peeled off cleanly.
得人精工，定制十年，服务全球，品质稳定，替代进口！
得人精工，定制十年，服务全球，品质稳定，替代进口！
扫一扫关注
公众号
在线交谈
DRMFG